KV 8405 Ball Bearing Drawer Slide with 1" Overtravel, 22" (Pair)

Knape & Vogt ball bearing slides roll like they are gliding on air. Designed for use on drawer box applications up to 24" wide and where the maximum weight load is not to exceed 100 pounds. Product features a 1" overtravel for optimum access to the back of the drawer box, and lever disconnect for easy drawer removal. KV ball bearing slides have three ball bearing per inch so weight is properly supported, and the ball bearing channel is round so more surface area of the bearings is utilized.

• Drawer Box Length: 22" (550mm)
• Slide Length: 22" (550mm)
• Width: 1/2" (12.4mm)
• Height: 1-13/16" (46mm)
• Load Capacity: 100 lbs.
• Finish: Anochrome
• Drawer Member Setback: 1/8" (3mm)
• Lever Disconnect For Easy Drawer Removal
• 32mm Hole Pattern With Direct Access Mounting
• NBH Number: 1278
• Item Number: 8405B 22

*Sold in Pairs. Screws and Rear Mount Brackets Not Included.

Important: Drawer Member Setback is 1/8". If slide is not installed with the proper setback the rubber stop that catches the drawer member and holds the drawer closed will wear out over time. Eventually this will cause "drawer creep" (the drawer will not stay closed). If a setback is used on the cabinet member of the slide, increase the setback on the drawer member by an equivalent amount so that the setback relationship is constant.